Caractéristiques
- Modèle: 1200,1300,500,870,88
- Type d'arme: Maverick,Mossberg,Remington,Winchester
- Poids du colis: 0,249kg
- Hauteur d'expédition: 30mm
- Largeur d'expédition: 51mm
- Longueur d'expédition: 467mm
- UPC: 758152513007
Le prix inclut la TVA mais pas la livraison .
Référence: 019000004
N° fabr.: SHS1300
758152513007 Fournie avec un ensemble complet d'adaptateurs et d'entretoises pour une installation sur les fusils à pompe de calibre 12 Mossberg 500, Maverick 88, Remington 870, et Winchester 1200/1300. Facile à installer, aucune modification de l'arme n'est requise. Acier formé avec des fentes de refroidissement allongées pour protéger vos mains des brûlures. Offre une surface de préhension sécurisée et antidérapante, ainsi qu'une dissipation thermique maximale. Il suffit de glisser sur le canon et de sécuriser avec le matériel fourni. La finition noire oxydée s'accorde avec la plupart des finitions de fusils de chasse. Aucun travail d'armurier requis pour s'adapter à la plupart des fusils à pompe de calibre 12 populaires.CARACTÉRISTIQUES : Acier, finition noire oxydée, mate. 13¾ (35cm) de long.
A good buy 25/01/2014
This was an easy install, it is not a custom piece built specific to any gun, it is built to fit every 870 ever made. Take your time and you won't damage the finish on your weapon or on the heat shield. The instructions are pretty clear and easily followed (I read them afterwards) no modification was required to my weapon (H&R Pardner Protector Pump) even though I installed an 870 wood stock and forearm and a +2 magazine extension. The heat shield does require a little patience for a good tight fit but looks good after installation. It is a great deal for quality and looks, especially because it it metal and cost the same as some synthetic models
1300 defender 05/03/2012
*this may not apply to all shotguns* The fit and finish of the product is unacceptable. During install the heat shield heavily scratches the barrel's finish. The receiver end of the shield does not grip the barrel well allowing it to move and produce wear on the barrel. The forward end, with the two screw holes, comes to you flared out and out of alignment. This neccesitates a lot of test fits and alterations which again damages the finish of the gun. A gunsmith might have better luck with it. Mine found its way into the dumpster.
Nous avons rencontré une erreur lors du chargement de ce contenu. Veuillez actualiser la page pour continuer. Si le problème persiste, contactez notre service client.