Caractéristiques
- Type d'arme: Universel Arme de Poing
- Poids du colis: 0,295kg
- Hauteur d'expédition: 61mm
- Largeur d'expédition: 109mm
- Longueur d'expédition: 119mm
- UPC: 617407958119
Le prix inclut la TVA mais pas la livraison .
Référence: 694000003
N° fabr.: P500
617407958119 La pince de maintien aide à empêcher le glissement de tourner dans le cadre du P500 en appliquant une force supplémentaire sur le dessus du glissement. Elle fournit un maintien sécurisé dans l'outil lors du travail avec des organes de visée ou des glissements difficiles à retirer, comme le Springfield Armory XD et le S&W M&P.Le Hold Down Clamp aide à prévenir la torsion de la glissière dans le cadre du P500 en appliquant une force supplémentaire sur le dessus de la glissière. Il offre un maintien sécurisé dans l'outil lors de travaux sur des organes de visée ou des glissières difficiles à retirer, comme celles du Springfield Armory XD et du S&W M&P.
doesn't work with 1911 21/12/2016
You set the slide in the moving jaw (manufacturer's terminology), hand tighten per manual, then use a pusher to push the sight. Simple enough.
Problem is, the jaw doesn't provide enough support for the slide, plus it is allowed to wiggle about a little bit. So when you are pushing the sight on top, the torque is trying to rip the slide out of the jaw. And it's almost succeeding, to the point when I had to stop for fear of damaging the slide. End result - sight not adjusted, the tool pretty useless.
The reason I had to adjust it was that I dropped the gun and the rear sight moved. So it could not be all that tight. And no, I didn't forget to unscrew the little screw. And I even heated up the slide.
P500 Sight Tool B&J Machine 28/06/2016
Seemed to work fine to remove a sight off a 1911, replacing the sight was something else. First- there is not enough room fit the pusher gaget an sight next to the dovtail and frame. Next- when pushing a tight rear sight, the frame bent causing the pusher gaget to mar the slide. The pusher tool also spun ruining the finish on the sight. I will have to replace the sight. Not worth the money and time to have to do everything over.
Nous avons rencontré une erreur lors du chargement de ce contenu. Veuillez actualiser la page pour continuer. Si le problème persiste, contactez notre service client.