Améliore ton tir avec le montage WALTHER 22 LEUPOLD DELTAPOINT PRO !
Le montage EGW pour le red dot sight est conçu pour être installé de gauche à droite (avec le canon pointé vers l'avant). La queue d'aronde a un taper progressif pour faciliter l'installation.
Il te suffit de retirer la hausse arrière de ton arme et de la remplacer par le montage EGW afin de fixer ton Leupold DeltaPoint Pro, JPoint, Redfield Accelerator ou Optima red-dot sight. Tu peux enlever le montage et remettre ta hausse arrière à tout moment. Le matériel de montage est inclus.
Instructions d'installation
- Retire la hausse arrière*
- Installe le montage EGW dans la queue d'aronde
- Serre la vis de réglage (si applicable)
- Place le red dot sight sur le montage EGW (en plaçant un petit morceau de papier entre le red dot sight et le montage, cela facilitera le retrait et empêchera le Loctite d'adhérer au red dot sight.)
- Applique du Loctite bleu sur les vis de montage fournies
- Serre les vis de montage à 15 in/lbs
La modification de ton arme à feu peut annuler la garantie du fabricant. Ce produit doit être installé et vérifié par un armurier qualifié. Aucune responsabilité n'est exprimée ou implicite pour les dommages ou blessures pouvant résulter d'une installation ou d'une utilisation incorrecte de ce produit.
Ce montage est compatible avec : Colt 1911/.22 Rail Gun (glissière Walther .22). Ce montage convient au Colt Rail Gun .22lr dont la glissière est fabriquée par Walther.
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount fits: Colt 1911/.22 Rail Gun (Walther .22 Slide) This mount fits the Colt Rail Gun .22lr that has the slide made by Walther.