Caractéristiques
- Modèle:
Commander
,Government
- Type d'arme:
1911
- Poids du colis: 0,018kg
- Largeur d'expédition: 83mm
- Longueur d'expédition: 146mm
Le prix inclut la TVA mais pas la livraison .
Référence: 168000128
N° fabr.: P28BC
Ensemble complet des 11 goupillons et plongeurs de précision pour rénover un 1911 existant ou pour en construire un nouveau de zéro. Traités thermiquement pour une excellente résistance à l'usure de surface et une longue durée de vie. Disponibles en acier au carbone bleui mat ou en acier inoxydable à finition naturelle.Le prix inclut la TVA mais pas la livraison .
Le 1911 PIN SET de CASPIAN est la solution idéale pour remplacer chaque pin de ton pistolet. Conçu pour la durabilité, ce set est traité thermiquement pour une résistance exceptionnelle à l'usure.
Ce set complet comprend les 11 pins et plungers de précision nécessaires pour rénover un 1911 existant ou pour en construire un nouveau de A à Z. Voici ce que tu obtiens :
Compatible avec les modèles 1911 Government et Commander ainsi que leurs clones, mais ne convient pas au modèle Officers.
Améliore ton expérience de tir et assure-toi que ton 1911 fonctionne comme neuf avec ce set de pins de qualité supérieure !
Commander,
Government
1911
Buyer Beware 27/12/2011
I bought this set of pins to finish out a 1911 build I'm doing for my wife. I ordered the Caspian Race Ready Receiver (168-100-110) for the build, so I figured I'd order this pin set since it's made by the same manufacturer. The ejector pin in this set is solid, and I think it's slightly oversize, as it bent while I was trying to install it into the ejector pin hole (yes, I had done the requisite notching of the ejector post, and there was no blocking of the hole when I looked thru it; I also should have measured the diameter of the pin against the diameter of the hole--I really think a roll pin is better for this application).
Additionally, if you decide to use the Cylinder and Slide Professional Trigger Kit (206-000-019), the hammer strut pin in this set is too large (the pin is .095 and the hole in the hammer is about .093). I reamed out the hole in the hammer, but it was still a very hard pin to drive in.
In the future, I will probably order a different set of pins. I may or may not order Caspian pins again, I haven't yet decided. The mainspring parts are all fine, as are the plunger pins and the sear and hammer pins.
I want to caveat the "Would you recommend this to a friend" question by saying I would recommend it, but I would also tell them what I experienced.
Nous avons rencontré une erreur lors du chargement de ce contenu. Veuillez actualiser la page pour continuer. Si le problème persiste, contactez notre service client.