Améliore ton tir avec le montage EGW pour Leupold DeltaPoint Pro !
Le montage EGW pour le Leupold DeltaPoint Pro est conçu spécifiquement pour le S&W M&P 22 Compact. Voici ce que tu dois savoir :
Description du produit
Les viseurs à point rouge EGW sont faits pour être installés de gauche à droite (avec le canon orienté vers l'avant). La queue d'aronde a un cône progressif pour faciliter l'installation.
Il te suffit de retirer la hausse arrière de ton arme et de la remplacer par le montage EGW afin d'installer ton viseur à point rouge Leupold DeltaPoint Pro, JPoint, Redfield Accelerator ou Optima. Tu peux enlever le montage et remettre ta hausse arrière à tout moment.
Matériel de montage inclus.
Instructions d'installation
- Retire la hausse arrière*
- Installe le montage EGW dans la queue d'aronde
- Serre la vis de réglage (si applicable)
- Place le viseur à point rouge sur le montage EGW (en plaçant un petit morceau de papier entre le viseur et le montage, cela facilitera le retrait et empêchera le Loctite d'adhérer au viseur).
- Applique du Loctite bleu sur les vis de montage fournies
- Serre les vis de montage à 15 in/lbs
La modification de ton arme à feu peut annuler la garantie du fabricant. Ce produit doit être installé et vérifié par un armurier qualifié. Aucune responsabilité n'est exprimée ou implicite pour les dommages ou blessures pouvant résulter d'une installation ou d'une utilisation incorrecte de ce produit.
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.