Améliore ton tir avec le montage EGW pour Vortex Viper/Venom !
Le montage de viseur EGW est conçu pour être installé de gauche à droite (avec le canon orienté vers l'avant). La queue d'aronde a un taper progressif pour faciliter l'installation.
Il te suffit de retirer le viseur arrière de ton arme et de le remplacer par le montage EGW pour y installer ton Vortex Viper/Venom, Burris FastFire ou Docter red-dot sight. Tu peux enlever le montage et remettre ton viseur arrière à tout moment. Matériel de montage inclus.
Instructions d'installation
- Retire le viseur arrière*
- Installe le montage de viseur EGW dans la queue d'aronde
- Serre la vis de réglage (si applicable)
- Place le viseur à point rouge sur le montage EGW (placer un petit morceau de papier entre le viseur à point rouge et le montage facilitera le retrait et évitera que le Loctite n'atteigne le viseur).
- Applique du Loctite bleu sur les vis de montage fournies
- Couple les vis de montage à 15 in/lbs
Vis fournies :
- 2 vis à tête bombée - Fournies pour les viseurs Vortex Viper et Venom
- 2 vis à tête plate - Fournies pour les viseurs Burris FastFire et Docter
Les vis incluses avec ce montage nécessitent une clé Allen de 5/64'' pour l'installation.
La modification de ton arme à feu peut annuler la garantie du fabricant.
Ce produit doit être installé et vérifié par un armurier qualifié.
Aucune responsabilité n'est exprimée ou implicite pour les dommages ou blessures pouvant résulter d'une installation ou d'une utilisation incorrecte de ce produit.
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.