Caractéristiques
- Poids du colis: 0,045kg
- Hauteur d'expédition: 13mm
- Largeur d'expédition: 76mm
- Longueur d'expédition: 254mm
- UPC: 050806023253
Le prix inclut la TVA mais pas la livraison .
Référence: 587036968
N° fabr.: 36968
050806023253 Conçu à l'origine pour les travailleurs du métal et les mécaniciens afin de retirer des boulons coincés, ces extracteurs robustes mordent dans le métal pour une meilleure traction, te permettant d'appliquer la force nécessaire pour retirer un choke qui refuse de bouger avec des outils ordinaires. Disponible pour les calibres 12 et 20. Instructions complètes incluses. Attention : des dommages au canon peuvent survenir en cas d'utilisation incorrecte.En rupture de stock, environ 4-12 semaines à partir de l'entrepôt principal.
Le prix inclut la TVA mais pas la livraison .
Conçu à l'origine pour les métallurgistes et les mécaniciens, cet outil robuste permet de retirer des chokes coincés avec facilité. Les extracteurs lourds mordent dans le métal pour une traction supplémentaire, te permettant d'appliquer la force nécessaire pour déloger un choke qui refuse de bouger avec des outils ordinaires.
Instructions complètes incluses. Attention : des dommages au canon peuvent survenir si l'outil est mal utilisé.
Didn't work 12/08/2014
I tried to remove a stuck choke tube from a Bennelli shotgun with no luck at all. I had previously talked with a Brownell's consultant and was told to follow the written instructions that came with the tool. I did that to the letter. The cutting edges of the tool were softer than the choke tube metal and merely broke away as I tried to twist the tool.
I finally had to try another method of removal which I found on Youtube. I used JB Weld to glue in a deep well socket that was about 1/8 of an inch smaller in diameter than the choke tube. After letting it set up for 24 hours I used a ratchet to remove the socket which bonded to the choke tube.
I would return the tool to Brownells except that postage would cost as much as the tool.
Worked well 02/04/2014
I had an inventor DS choke tube stuck in an A5 thats about a year old. Tried everything to get the choke out to the point where wrenches wore the notches on the tube.
I bought this tool as a hail mary before relenting and going to a gunsmith. It took a couple tries and tapping the tool in harder, but with a crescent wrench and a couple sharp raps with a hammer to the tool was finally able to get the tube out. No damage to barrel, choke was not any more messed than before, junking it though.
You might have drive the tool in a little harder than you think.
Good price shipping was good, fedex is always good.
Nous avons rencontré une erreur lors du chargement de ce contenu. Veuillez actualiser la page pour continuer. Si le problème persiste, contactez notre service client.