Découvre le montage Trijicon RMR pour S&W M&P 22 Compact !
Voici le montage parfait pour ta visée Trijicon RMR sur le S&W M&P 22 Compact. Fabriqué par EGW, ce montage est conçu pour être à la fois robuste et facile à installer.
Détails du produit :
- Matériau : Aluminium 7075
- Revêtement : Mat noir dur
- Longueur totale : 1.780"
- Largeur totale : 1.1"
- Matériel de montage : (2) vis à tête plate 6-32, (1) vis de réglage 6-32 X 3/16
- Compatibilité des points rouges : Trijicon RMR, Holosun HS507C
Ce montage convient à :
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Ce montage ne convient pas à :
Pour installer le montage, il te suffit de retirer la hausse arrière de ton arme et de la remplacer par notre montage, sans aucune modification requise. Tu peux enlever notre montage et remettre ta hausse arrière à tout moment. Le matériel de montage est inclus.
Instructions d'installation :
- Retire la hausse arrière*
- Installe le montage EGW dans la queue d'aronde
- Serre la vis de réglage (si applicable)
- Place le point rouge sur le montage EGW (en plaçant un petit morceau de papier entre le point rouge et le montage, tu facilites le retrait et évites que le Loctite n'atteigne le point rouge.)
- Applique du Loctite bleu sur les vis de montage fournies
- Serre les vis de montage à 15 in/lbs
Vis à tête plate fournies pour Trijicon RMR : Les vis incluses avec ce montage nécessitent une clé Allen de 5/64'' pour l'installation.
Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.