Il suffit de retirer la hausse de votre arme et de la remplacer par le support EGW pour monter votre viseur red-dot Trijicon RMR. Vous pouvez retirer le support et remplacer votre hausse à tout moment. Matériel de montage inclus. Instructions d'installation Retirez la hausse* Installez le support de visée EGW dans la queue d'aronde Serrez la vis de réglage (si applicable) Placez le viseur red-dot sur le support de visée EGW (placer un petit morceau de papier entre le viseur red-dot et le support de visée facilitera le retrait et empêchera le Loctite de se coller au viseur red-dot.) Appliquez du Loctite bleu sur les vis de montage fournies. Serrez les vis de montage à 15in/lbs. Les vis incluses avec ce support nécessitent une clé Allen de 5/64'' pour l'installation. Ce support ne convient pas : S&W M&P S&W M&P 2.0 S&W M&P 22
Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Trijicon RMR red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fits: S&W M&P S&W M&P 2.0 S&W M&P 22